Subroutine 58 (Mm_Main) - Siemens SINUMERIK 808D ADVANCED Series Commissioning Manual

Name Type
Err1 BOOL
Assigned global variables
ChuckLcked BOOL
ChuckLckLED BOOL
ExtInLED_Om BOOL
TR_Status BOOL
Relevant PLC machine data
No. Value
14512 [17].1 1
0
14512 [21].1 0
1
Example for calling subroutine 56
6.6.31

Subroutine 58 (MM_MAIN)

Purpose
To use subroutine 58, you must have licensed the optional Manual Machine Plus function for the SINUMERIK 808D
ADVANCED T (Turning). The subroutines 46, 58 and 59 must be used together. This subroutine is used to control the
manual machine function after the manual machine interface is activated.
Local variable definition
Inputs
Name
TK_X_P
TK_X_M
TK_Z_P
TK_Z_M
RAPID
SP_CW
SP_CCW
SP_STOP
NC_START
NC_STOP
AUTO_ENABLE
MDA_ENABLE
172
Description
Error 1: clamp/unclamp not possible while spindle is operating
M229.4 Chuck clamped
M239.2 Chuck at released state
M239.5 External/inside clamping state
M237.6 Chuck release command
Description
Enable chuck in turning
Disable chuck in turning
Set I0.0 to I2.7/Q0.0 to Q1.7 as the standard I/O wiring in the default PLC
Set I6.0 to I8.7/Q4.0 to Q5.7 as the standard I/O wiring in the default PLC
Type
BOOL
BOOL
BOOL
BOOL
BOOL
BOOL
BOOL
BOOL
BOOL
BOOL
BOOL
BOOL
Description
Traverse key X plus
Traverse key X minus
Traverse key Z plus
Traverse key Z minus
Rapid traverse key
Start signal spindle CW
Start signal spindle CWW
Stop signal spindle
NC start signal
NC stop signal
Switching to AUTO is enabled in Manual Machine Mode
Switching to MDA is enabled in Manual Machine Mode
Commissioning Manual
6FC5397-4EP10-0BA8, 07/2018