Siemens SINUMERIK 808D ADVANCED Series Commissioning Manual page 165

Local variable definition
Inputs
Name Type
Tmax WORD
C_time WORD
M_time WORD
T_polar BOOL
T_key BOOL
T_01 to T_06 BOOL
OVload BOOL
Outputs
Name Type
T_cw BOOL
T_ccw BOOL
T_LED BOOL
ERR1 BOOL
ERR2 BOOL
ERR3 BOOL
ERR4 BOOL
ERR5 BOOL
ERR6 BOOL
Assigned global variables
T_cw_m M156.0
T_ccw_m M156.1
CcwDelay M156.2
K_active M156.3
Tpos_C M156.4
Tp_eq_Tc M156.5
Tp_eq_0 M156.6
T_P_INDX MD160
T_CHL M168.4
Tm1_FindT T15
T_CLAMP T13
Relevant PLC machine data
No. Unit
14510 [20] -
14510 [21] 0.1 s
14510 [22] 0.1 s
14512 [17].0 -
14512 [21].1 -
Commissioning Manual
6FC5397-4EP10-0BA8, 07/2018
Description
Number of tool on the turret, only 4, 6 are permitted
Turret clamping delay time (unit: 0.1 s)
Monitor time for searching for a tool (unit: 0.1s)
Tool position signal: NC/NO
Manual tool change key
Tool position sensor (low active)
Turret motor overload (NC)
Description
Turret CW for tool change
Turret CCW for turret clamping
Turret change status display
Error1: no turret position signal available
Error2: programmed tool exceeds turret range
Error3: tool searching time monitor time out
Error4: turret overload
Error5: max tool number setting error
Reserved
Position marking for turret CW rotation
Position marking for turret CCW rotation
Turret CCW rotation delay
Manual key active
Turret position changed
Programmed tool number equal to the current tool number
Programmed tool number equal to zero
Monitoring the tool change buffer zone in JOG mode
Operating mode locked
Monitoring timer for tool searching
Clamping timer for turret 1
Description
Max. tool number (4 or 6)
Turret clamping time
Monitoring time for tool searching
Activating the turret function of a turning machine
Switch of the I/O interface (0: set I0.0 to I2.7/Q0.0 to Q1.7 as the standard I/O wiring in
the default PLC; 1: set I6.0 to I8.7/Q4.0 to Q5.7 as the standard I/O wiring in the de-
fault PLC)
165