Synchronizing Drive Data Files Between Nc And Drive - Siemens SINUMERIK 808D ADVANCED Series Commissioning Manual
Hide thumbs
Also See for SINUMERIK 808D ADVANCED Series:
- Diagnostic manual (566 pages) ,
- Parameter manual (524 pages) ,
- Commissioning manual (508 pages)
Table of Contents
Advertisement
5.2
Synchronizing drive data files between NC and drive
The NC always compares its data backup with the drive data upon every startup.
● If no data backup files can be found, the NC creates a new backup file automatically with the following message
displaying on the screen:
● If the drive data differs from the NC data backup, data synchronization is required for synchronizing the drive data files
between the NC and the drives.
Operating sequence
Commissioning Manual
6FC5397-4EP10-0BA8, 07/2018
1.
Press this softkey to enter the setting window when the following data synchronization dia-
log box appears.
Note: a password input field appears in this dialog if you have not set an access level on the
control system. For more information, see Section "Setting the password (Page 122)".
If you cancel the data synchronization with the following softkey, this dialog appears again
on next NC startup.
2.
Select a drive for which you desire to perform the data synchronization.
3.
Press this key to choose a synchronization method for the selected drive.
4.
Press this softkey to confirm your settings and start the data synchronization.
121
Advertisement
Table of Contents
