Siemens SINUMERIK 808D ADVANCED Series Commissioning Manual page 44
Hide thumbs
Also See for SINUMERIK 808D ADVANCED Series:
- Diagnostic manual (566 pages) ,
- Parameter manual (524 pages) ,
- Commissioning manual (508 pages)
Table of Contents
Advertisement
Establishing a network connection
Proceed through the following steps to establish a network connection:
+
44
6.
Double-click the access point symbol, and the following "Set PG/PC Interface" dialog box is
displayed.
Select "TCP/IP" with the Ethernet card name of your computer and click the "OK" button.
Note: You can find the name of your Ethernet card in the local area connection status under
Control Panel on your computer.
7.
Enter the IP address for the control system that displays in the above link setup dialog box
in the communication settings dialog box.
8.
Double-click this symbol in the communication setting window to establish a connection to
the specified IP address.
Wait until the information of the connected control system is identified as follows, and then
the connection is ready.
1.
Connect the control system with the local network using an Ethernet cable.
2.
Select the system data operating area on the PPU.
3.
Press this key to view the extended softkeys.
4.
Enter the main screen of the service control options through the following softkey opera-
tions:
→
Commissioning Manual
6FC5397-4EP10-0BA8, 07/2018
Advertisement
Table of Contents
