Transferring The Desired Files To The Control System - Siemens SINUMERIK 808D ADVANCED Series Commissioning Manual
Hide thumbs
Also See for SINUMERIK 808D ADVANCED Series:
- Diagnostic manual (566 pages) ,
- Parameter manual (524 pages) ,
- Commissioning manual (508 pages)
Table of Contents
Advertisement
13.5.7
Transferring the desired files to the control system
Proceed as follows to transfer the required files to the control system.
Prerequisite: A USB memory stick which contains all required files is inserted into the USB interface at the front of the PPU.
Transferring the user cycle file
+
Transferring the bitmap file
Commissioning Manual
6FC5397-4EP10-0BA8, 07/2018
1.
Select the system data operating area.
2.
Open the USB storage directory through the following softkey operations:
→
3.
Select the desired user cycle file (for example, CYCLE100.SPF) and then press this softkey
to copy the file.
4.
Press this softkey to open the user cycle directory.
5.
Press this softkey to paste the file.
1.
Press this softkey to switch to the USB storage directory.
2.
Select the desired bitmap file(s) (for example, cn1.bmp, cn2.bmp...) and then press this
softkey to copy the file(s).
Note that you can use the following key to select multiple files:
3.
Press this softkey to open the window of system data.
4.
Find the folder for storing the user cycle files through the following operations, and press
this key to open it:
5.
Press this key to open the following user cycle bitmap file folder:
→
→
259
Advertisement
Table of Contents
