Ipv4 And Ipv6 - Avaya 9600 Series Installing And Administering

Initial setup and connectivity
Parameter Set to
DHCP lease Option 51, if received
time
DHCP lease Option 58, if received
renew time
DHCP lease Option 59, if received
rebind time
DOMAIN Option 15, if received
DNSSRVR Option 6, if received, which can be a list of IP addresses
HTTPSRVR The siaddr parameter, if that parameter is non-zero
IPADD The yiaddr parameter
LOGSRVR Option 7, if received
MTU_SIZE Option 26
NETMASK Option 1, if received
ROUTER Option 3, if received, which might be a list of IP addresses
SNTPSRVR Option 42

IPv4 and IPv6

• If IPV6STAT is set to 1, that is, IPv6 is supported, then the DHCPSTAT parameter is selected:
- If DHCPSTAT is set to 1, that is, use DHCPv4 only, then IPv4 only is enabled.
- If DHCPSTAT is set to 3, that is, both IPv4 and IPv6 supported, then dual-stack operation
is enabled.
The phones in this release support the following combinations of IPv4 and IPv6 IP address
configuration:
• Dual mode: Both IPv4 and IPv6 addresses are configured by using static addressing.
• Dual mode: Both IPv4 and IPv6 addresses are configured by using DHCP.
• IPv4 only mode.
The following table provides the results of the determination:
Table 1: IP Enablement Results
Manually IPV6STAT
programmed
IPv4 address
No 0
January 2020 Installing and Administering Avaya 9601/9608/9611G/9621G/9641G/9641GS IP
DHCPSTAT Result
NA IPv4 only
Deskphones SIP
Comments on this document? infodev@avaya.com
Addressing modes
IPv4 IPv6
DHCP NA
Table continues...
30