Avaya 9600 Series Installing And Administering page 23

System parameter
name
L2Q, L2QVLAN
SIP_CONTROLL
ER_LIST
TLSSRVR and
HTTPSRVR
L2Q
POE_CONS_
SUPPORT
January 2020 Installing and Administering Avaya 9601/9608/9611G/9621G/9641G/9641GS IP
TLV name Impact
TIA LLDP MED L2Q - set to 2 (off) if T (the Tagged Flag) is set to 0 and to 1
Network Policy (on) if T is set to 1.
(Voice Signaling)
L2QVLAN - Set to the VLAN ID in the TLV.
L2QAUD - Set to the Layer 2 Priority value in the TLV.
DSCPAUD - Set to the DSCP value in the TLV.
A check is made as to whether a reset is necessary to obtain a
new IP address due to a change in the values of the
parameters L2Q or L2QVLAN.
This TLV is ignored if:
• The value of USE_DHCP is 0 and the value of IPADD is not
0.0.0.0.
• The Application Type is not 1 (Voice) or 2 (Voice Signaling).
• The Unknown Policy Flag (U) is set to 1.
Proprietary Call SIP_CONTROLLER_LIST will be set to the IP addresses in
Server TLV this TLV value.
Proprietary File TLSSRVR and HTTPSRVR will be set to the IP addresses in
Server TLV this TLV value.
Proprietary 802.1 Q If the value of TLV = 1, L2Q is set to 1 (On).
Framing
If the value of TLV = 2, L2Q is set to 2 (Off).
If the value of TLV = 3, L2Q is set to 0 (Auto).
A check is made as to whether a reset is necessary to obtain a
new IP address due to a change in the values of the
parameters L2Q or L2QVLAN.
This TLV is ignored if:
• The value of USE_DHCP is 0 and the value of IPADD is not
0.0.0.0.
• The current L2QVLAN value was set by an IEEE 802.1
VLAN name.
• The current L2QVLAN value was set by a TIA LLDP MED
Network Policy (Voice) TLV.
Proprietary - PoE If the value of POE_CONS_SUPPORT is 1,
Conservation Level POE_CONS_MODE is set to the level requested in the TLV.
Request TLV
Comments on this document? infodev@avaya.com
Note:
This parameter cannot be used in an environment where
both SIP phones and H.323 phones exist.
Deskphones SIP
Configuration through LLDP
23