Avaya 9600 Series Installing And Administering page 222

List of configuration parameters
Parameter name
PHONE_LOCK_IDLETIME
PHY1STAT
PHY2_AUTOMDIX_ENABLED
PHY2PRIO
January 2020 Installing and Administering Avaya 9601/9608/9611G/9621G/9641G/9641GS IP
Default
value
0
1
1
0
Deskphones SIP
Comments on this document? infodev@avaya.com
Description
Specifies the interval of idle time, in
minutes, after which the phone will
automatically lock.
Valid values are from 0 to 10080.
Value operation:
• 0: Phone will not lock
automatically.
Specifies the speed and duplex
settings for the Ethernet line
interface.
Value operation:
• 1: auto-negotiate
• 2: 10Mbps half-duplex
• 3: 10Mbps full-duplex
• 4: 100Mbps half-duplex
• 5: 100Mbps full-duplex
• 6: 1Gbps full-duplex, if supported
by hardware, otherwise auto-
negotiated
Specifies whether auto-MDIX is
enabled on PHY2.
Value operation:
• 0: auto-MDIX is disabled.
• 1: auto-MDIX is enabled.
Specifies the layer 2 priority value to
be used for frames received on the
secondary Ethernet interface when
VLAN separation is enabled. The
parameter is not supported when
VLANSEPMODE is 1.
Valid values are 0 through 7.
Note:
J129 does not support this
parameter.
Table continues...
222