FUTABA T32MZ Instruction Manual page 97

The Timer function may be set for any desired time,
i.e. engine run time, specified times for competitions,
etc. Two independent timers are provided for your use.
The timers are stored independently with each model,
meaning that when you switch between model setups,
the timer associated with the new model is brought up
automatically.
The timers may be set to start and stop from the motion
of any switch or stick. You may set the ON and OFF
directions freely. Each timer has a capacity of up to 59
minutes 59 seconds.
Each timer may be set for count-down or count up
operation with your choice of a target time. Also split
time may be set up and counted.
If a target time is set and the timer reaches this point, a
buzzer will sound for each count generated.
Countdown timers sound one short beep during the last
twenty seconds and two short beeps during the last ten
seconds before reaching the target, then a long tone at
the target time, and continue counting with displaying a
minus (-) sign. Count-up timers also beep the last twenty
and ten seconds, beep the target time, and keep counting
upwards until shut down.
<Lap time list>
＜ Linkage Menu ＞
97