FUTABA T32MZ Instruction Manual page 48

1. Model addition and call
Default settings assign one model to the T32MZ transmitter.
To add new models or select previously setup models, use the
Model Select function in the Linkage Menu.
When a new model is added, relink with the receiver used in
that model.
This is convenient when calling a model after registering the
model names in advance.
The currently selected model is displayed at the top of the
Please be aware that the transmitter will stop transmitting
when you change the model.
When a new model is added, the model type select screen/
system mode/receiver link automatically appears. Please be
aware that the transmitter will stop transmitting when you
change the model..
2. Model type and swash type selection
When a separate model type is already selected, select
helicopter with the Model Type function of the Linkage Menu,
and then select the swash type matched to the helicopter.
＜ Model Basic Setting Procedure ＞
48
3. Flight condition addition
model. You can assign all switches including sticks, switches,
switches. You can also add delayed mixing to these functions
in order to avoid sudden changes. Moreover, you can set
condition. In addition, you can copy conditions and/or change
what switches and/or controls are used to activate each flight
condition.
The Condition Select function automatically allocates the
default Condition 0 (Normal) for each model type. Condition
0 (Normal) is the only one active when a new model type is
defined. This condition is always ON, and remains ON until
other conditions are activated by switches.
The Condition Delay can be programmed for each channel.
The Condition Delay is used to change the servo throw smoothly
when switching conditions.
switch OFF)
center)
forward side)
The priority is throttle hold/idle up 2/idle up 1/normal.
Throttle hold has the highest priority.
Add other conditions, as required.