FUTABA T32MZ Instruction Manual page 50

condition select switch.
*Pitch curve graph display can be switched to pitch angle
direct reading display.
Make the pitch at hovering approximately +5º~6º.
Set the pitch at hovering with the stick position at
*Stability at hovering may be connected to the throttle curve.
Adjustment is easy by using the hovering throttle function
and hovering pitch function together.
º as standard.
º
The standard is +8º.
the high and low sides.
[Pitch angle setting example]
º º
6. Throttle hold setting
Call the Throttle Hold function from the Model Menu and
switch to the throttle hold condition with the condition select
switch.
Note:
group mode. Since this function is not used at other
conditions, switch to the single mode before setting.
The throttle hold function allows setting for throttle
position by switch for training. Either one or both
functions can be performed.
＜ Model Basic Setting Procedure ＞
50
This function sets the servo operation position at
throttle hold. (Throttle cut and idle positions)
[Speed].
Use this function when you want to suppress the torque
generated by the changes in the pitch and speed of the main
rotor during pitch operation. Adjust it so that the nose does not
swing in the rudder direction. However, when using a heading
hold gyro like those shown below, do not use Pitch to RUD
mixing.
Note
not be used. The reaction torque is corrected at
mode, the mixed signal will cause neutral deviation
symptoms and the gyro will not operate normally.
Call the Pitch to RUD mixing function from the Model
Menu, and set the curve for each condition. (At initial setting,
this function is in the "INH" state. To use it, set it to the "ON"
state.)
(17 points curve)
Curve setting of up to 17 points is possible. However, in the
following setting example, a simple curve can be adjusted by
using the [Linear] curve type.
Note:
condition only, switch to the single mode.
Call the mixing curve of each condition with the condition
select switch.