FUTABA T32MZ Instruction Manual page 75

The Linkage Menu has all of the functions you will
need to perform model addition, model type selection,
frequency setting, end point setting, and other model
basic settings.
Displays the servo test and operation position
Model addition, call, deletion, copy, model name setting
Model type, wing type, switch type, etc. selection
Picture selection and setting for each model
Sound recording and playback
System selection, receiver link, telemetry.
Channel assignment of each function can be changed
Adjusts the neutral position of each servo
Servo direction reversal
Fail safe function and battery fail safe function setting
Servo basic rudder adjustment and limit setting
Stops the engine safely and easily (airplane and helicopter only)
Lowers the idle speed of the engine (airplane and helicopter only)
Swash AFR and linkage correction function (helicopter only)
Timer setting and lap time display
Dial, slider, and digital trim position display and setting
Function Name can be changed
Displays various data sent from the receiver
Various telemetry sensors setting
Change of a sensor name
Data logging of telemetry
Warning sound and vibration setting
Model memory data reset (by various item)
Create an original menu that you often use
The functions which can be selected depend on which
model type you are using. A typical menu screen is
shown below.
＜ Linkage Menu ＞
75