Storage And Disposal Precautions; Other Precautions - FUTABA T32MZ Instruction Manual

microSD Card (Commercial Product) Handling Precautions
WARNING
Never disassemble or modify the microSD card.
Do not bend, drop, scratch or place heavy ob-
jects on the microSD card.
If smoke or an abnormal odor emanates from the
card, immediately turn off the transmitter power.
CAUTION
Since the microSD card is an electronic device,
be careful of static electricity.
■ Static electricity may cause erroneous operation or
other trouble.
Do not use the microSD card near radio and
television sets, audio equipment, motors and
other equipment that generates noise.
■ Doing so may cause erroneous operation.
Do not store the microSD card in the following
places:
・ Where the humidity is high
・ Where the temperature difference is severe
・ Where it is very dusty
・ Where the card will be exposed to shock and vibration
Storage and Disposal Precautions
WARNING
Keep wireless equipment, batteries, aircraft,
etc. away from children.
CAUTION
Do not store wireless devices in the following
places:
・ Where it is extremely hot (40℃ [104 ℉ ] or higher) or
cold (-10℃ [14 ℉ ] or lower)
・ Where the equipment will be exposed to direct sunlight
・ Where the humidity is high
・ Where vibration is prevalent
・ Where it is very dusty
・ Where the device may be exposed to steam and heat
Other Precautions
CAUTION
Do not directly expose plastic parts to fuel, oil,
exhaust gas, etc.
■ If left in such an environment, the plastic may be dam-
aged.
■ Since the metal parts of the case may corrode, always
keep them clean.
Join the Academy of Model Aeronautics.
■ The Academy of Model Aeronautics (AMA) provides
Do not use the microSD card where it may be
exposed to water, chemicals, oil, or other fluids.
■ Doing so may cause a fire or electric shock by short
circuiting.
・ Near speakers and other magnetic devices
Do not insert foreign matter into the transmit-
ter card slot.
■ Doing so may cause erroneous operation.
Do not expose the card to shock and vibration
and do not remove the card from the card slot
while data is being written or read.
■ The data may be damaged or lost.
● Recorded data
T h e d a t a r e c o r d e d o n t h e m i c r o S D c a r d
c a n n o t b e c o m p e n s a t e d r e g a r d l e s s o f t h e
c o n t e n t s o r c a u s e o f t h e t r o u b l e o r o b s t r u c t i o n .
Futaba does not perform data restoration or recovery work.
When the device will not be used for a long
time, remove the batteries from the transmitter
and aircraft and store them in a dry place where
the temperature is between 0℃ and 30℃ [32
and 86 ℉ ].
■ Leaving batteries inside your model and radio when
they are not being used for long periods will result in
battery deterioration, liquid leakage and other dam-
age.
guidelines and liability protection should the need
arise.
Always use genuine Futaba products such as
transmitter, receiver, servo, ESC, battery, etc.
■ Futaba is not responsible for damage sustained by
combination with parts other than Futaba Genuine
Parts. Use the parts specified in the instruction man-
ual and catalog.
℉
＜ Introduction ＞
9