Setup of Media ([MEDIA SETTING] menu)
Start the [MEDIA SETTING] menu after performing the initial adjustment.
P.1, "Performing the Initial Adjustment (Correcting for Misalignment in Bidirectional Printing More Precisely)"
Only Printing: Perform the procedure
Print & Cut: Perform all the procedure
Note: If any setting is not needed for each setting item, you can go to the next menu by selecting [NEXT].
1.
Starting the [MEDIA SETTING] menu.
Load media.
Check that no sagging is found on the media. If any sagging exists, the followed correction value settings
do not work effectively.
User's Manual, "Loading Media"
MENU
MEDIA SETTING
2.
Adjusting the Print Head Height.
HEAD HGT LOW
[CHANGE]
NEXT
HEAD HEIGHT
HIGH
LOW
Continued on the next page
Setup of Media ( [MEDIA SETTING] menu )
1.
5.
9
to
, and
.
1.
9
to
.
Press
.
When the left figure is displayed, press
Press
to select [CHANGE].
Press
to enable the setting.
When the left figure is displayed, open the front cover.
.
3