Checking Supplied Items; Part Names And Functions; Front View - Roland CAMM-1 User Manual

1 Checking Supplied Items

Check the following to make sure that you received all the items that were shipped along with the unit.
Power cord: 1
Cutter tool (for trimming
material) : 1
* CM-24 only
User's manual: 1

2 Part Names and Functions

2-1 Front View

Grit Roller
This moves the material to the front and rear.
Pinch Roller (Left)
Press material against the grit roller.
This is aligned with the left edge of the
loaded material and set in place.
Guide Line Marks
Material is loaded in alignment
with the guide-line marks.
Blade Protector
Knife Guide
Platen
Parallel (Centronics) Input Connector
In a parallel configuration, this connector is where you need to connect the parallel cable in order to communicate with your computer.
Serial (RS-232C) Input Connector
In a serial configuration, this connector is where you need to connect the serial cable that is used to communicate with your computer.
Blade (ZEC-U1005) : 1
Tweezers: 1
* CM-24 only
CAMM-1 DRIVER
®
for Windows 95 : 1
Pinch Roller (Right)
Press material against the grit roller. This is aligned with the right edge of the
loaded material and set in place.
Operation Panel
Pen Force Control Slider
Sets the blade force to be used with the tool.
Blade holder
(XD-CH3) : 1
Material for test cuts: 1
Test-use application tape: 1
* In this manual, the sections that explain both the CM-24 and
the CM-12 shown only illustrations of the CM-24.
Cutting carriage
The tool (blade or plotting pen) is installed here.
The cutting carriage performs the cutting by
moving the tool left/right or up/down.
Roller base: 1
* CM-24 only
DIP Switches
Used to make various settings.
5