Performing A Self-Test - Roland Camm-1 CX-24/12 User Manual

5 Performing a Self-test

5 Performing a Self-test
The CX-24/12 is equipped with a "self-test" function to conveniently allow you to check whether or not it is capable of operating
normally. If the CX-24/12 is not performing correctly, follow the steps below to perform a self-test.
A computer is not required in order to carry out the self-test.
1 Refer to "4-1 Installing a
holder to the cutting carriage on CX-24/12.
2
Hold down the [ ] key on the panel while you turn
the power on.
Refer to "4-2 Loading the
3
material.
When the display shows the screen at right, press the
4
[ENTER] key to start the operation check.
Operations is normal if the figure shown at right is
cut.
34
Blade" and install the blade
Material" and load the
CX-24
SELECT | ROLL
CX-12
SETUP -> ENTER