Setting The Height Of The Media Automatically - Roland VersaUV LEF-300 First Step Manual

First Time Printing
Securing the media in place with tape
If you do not want to use the suction function and for media that cannot be secured in place with the suction
function, secure the media in place using a substance such as commercially available tape affixed directly to
the flat table.
4.
Close the front cover.

2. Setting the Height of the Media Automatically

The height of the media is automatically detected, and the print heads are adjusted to the appropriate height
for printing.
MEMO
• If the print surface is uneven, there is a limit to the area of unevenness.
" For details, see the "Master Guide. "
• You can manually set the height of the media. The automatic height setting is not suitable if you do not
want to make the head gap sensor come into contact with the media. In this case, you should set the height
manually.
" For details, see the "Master Guide. "
NOTE
Be sure to hold the handle of the front cover and open and close it gently.
1.
Press [SETUP].
[SETUP] starts to flash.
" If you want to turn the suction function off, see the "Master Guide" for details.
2.
Press [ ], [ ], [UP], or [DOWN] to move the flat table.
Bring the highest position of the media (print surface) into contact with the head gap sensor. When the head
gap sensor reacts, a buzzer goes off.
HEIGHT:000.0mm
48
Secure the media in place using a substance such as com-
mercially available tape affixed directly to the flat table.
Media