Setting Up The Machine; Step 1: Removing The Retainers - Roland SF-200 Setup Manual

Setting Up the Machine

Step 1: Removing the Retainers
Retainers are attached to the machine to protect it from vibration during transportation. When installation is
complete, remove these.
WARNING
IMPORTANT
• Make sure to remove all the retainers. Any that remain may cause faulty operation or breakdown when the
power is switched on.
• Store the retainers carefully because they are needed again when transporting the machine.
• For transportation of this machine, contact your authorized Roland DG Corporation dealer.
Procedure
A
Open the front cover.
IMPORTANT
Be sure to hold the handle of the front cover and keep holding it until the cover is completely opened or
closed.
If you do not open and close the front cover gently, it may break or you may be injured.
B
Open the panel cover.
Remove the screw on the top of the panel cover, and then pull out the panel cover in the direction
indicated by the arrow.
Carry out these operations before you connect the power cord.
Inadvertent powerup may result in pinched hands or other injury.
2.Installation
23