15 Setting for Each Function
Creating the Plotting on Section Film
When using a section film in plotting, the slightest discrepancy in the angle of the paper setting will result in a
discrepancy between the measured angle and the actual plotting. In order to avoid such a discrepancy, the DPX has
a feature to set a total of four points.
* The optional digitizing scope can be used to set points with greater accuracy.
[Example of setting the points]
It is recommended to set the points shown below (except for the offset point) on the thin lines instead of the thick
lines (which are used to indicate the outer frame) on the section film.
4) Y correction point
2) Base point
1) Offset point
Installing the pen (or optional digitizing scope)
Install the pen on an unoccupied pen stock. When installing the optional digitizing scope, remove the pen cap
rubber before installing the device on the pen stock.
Press the
key once
with the top menu displayed.
When using a digitizing scope
Make sure that the pointer of the
digitizing scope (indicated with
"
") is located as shown in the
figure. In addition, if the pen is
positioned downward, be sure to
look down the digitizing scope
from the top.
Digitizing scope
Press
the pen stock where the pen (or digitizing scope)
will be installed.
Press the
and the pen (or digitizing scope) is loaded in the
pen carriage.
n
25
3) X correction point
or
to select the number of
key to confirm the selection,