Technical Data And Characteristics - Siemens SIMOTICS L-1FN3 Configuration Manual

Technical data and characteristics

The technical data and characteristics for the 1FN3 linear motors are stated in this chapter.
This data collection provides the motor data required for configuration and contains a
number of additional data for more detailed calculations for detailed analyses and problem
analyses.
Parameters that are used in the drive system for the control of a drive can differ from the
data specified here.
Technical data subject to change.
Note
System-specific data refer to the combination of 1FN3 linear motors with SINAMICS S120
drive systems.
Unless otherwise stated, the following constraints apply here:
• The DC link voltage U
• The motor is water-cooled with the recommended minimum volume flow rate V ̇
according to the data sheet and a water flow temperature T
• The rated temperature of the motor winding T
• Voltages and currents are specified as rms values.
• Installation altitude of the motors up to 2000 m above sea level.
1FN3 linear motors
Configuration Manual, 10/2018, 6SN1197-0AB86-0BP2
is 600 V, the converter output voltage U
DC a max
of 35 °C
VORL
is 120 °C
N
6
is 425 V
P ,H,MIN
165