Siemens SIMOTICS L-1FN3 Configuration Manual page 30

Description of the motor
2.3 Technical features and environmental conditions
Where applicable, the SIMOTICS motor series are in conformance with the following parts of
IEC / EN 60034:
Feature
Degree of protection
Cooling
Type of construction
Connection designations
Noise levels
Temperature monitoring
Vibration severity grades
Standard component, e.g. cannot be applied to built-in motors
1)
Relevant directives
The following directives are relevant for SIMOTICS motors.
European Low-Voltage Directive
SIMOTICS motors comply with the Low-Voltage Directive 2014/35/EU.
European Machinery Directive
SIMOTICS motors do not fall within the scope covered by the Machinery Directive.
However, the use of the products in a typical machine application has been fully assessed
for compliance with the main regulations in this directive concerning health and safety.
European EMC Directive
SIMOTICS motors do not fall within the scope covered by the EMC Directive. The products
are not considered as devices in the sense of the directive. Installed and operated with a
converter, the motor – together with the Power Drive System – must comply with the
requirements laid down in the applicable EMC Directive.
Eurasian conformity
SIMOTICS motors comply with the requirements of the Russia/Belarus/Kazakhstan (EAC)
customs union.
China Compulsory Certification
SIMOTICS motors do not fall within the scope covered by the China Compulsory
Certification (CCC).
CCC negative certification:
CCC product certification
(https://support.industry.siemens.com/cs/products?search=CCC&dtp=Certificate&mfn=ps&o
=DefaultRankingDesc&pnid=13347&lc)
28
1)
1)
1)
Standard
IEC / EN 60034-5
IEC / EN 60034-6
IEC / EN 60034-7
IEC / EN 60034-8
IEC / EN 60034-9
IEC / EN 60034-11
IEC / EN 60034-14
Configuration Manual, 10/2018, 6SN1197-0AB86-0BP2
1FN3 linear motors