USING THE CONTROL PANEL
DTR Polarity Setting Screen
When you press the [Change] button for the DTR Polarity option, the DTR
Polarity Setting screen displays.
You use this screen to specify the polarity of the DTR for the serial port
from the host. The options are as follows:
High
Low
The default is High.
Stop Bits Setting Screen
When you press the [Change] button for the Stop Bits option, the Stop Bits
Setting screen displays.
You use this screen to specify the number of stop bits in each character.
The options are as follows:
1
2
The default is 1.
Note: You must set the stop bits for the serial port to the same stop bit
setting as the host.
2-40