ZyXEL Communications XS3800-28 Cli Reference Manual page 233
Hide thumbs
Also See for XS3800-28:
- User manual (789 pages) ,
- Quick start manual (2 pages) ,
- User manual (593 pages)
Table of Contents
Advertisement
Table 158 OSPF Command Summary (continued)
COMMAND
redistribute rip metric-type <1|2>
metric <0-16777215>
redistribute rip
no redistribute rip
redistribute static metric-type <1|2>
metric <0-16777215>
redistribute static
no redistribute static
passive-iface <ip-addr/bits>
no passive-iface <ip-addr/bits>
summary-address <ip-address> <mask>
no summary-address <ip-address> <mask>
show router ospf summary-address
ipv6 router ospf <router-id>
area <area-id>
no area <area-id>
area <area-id> default-cost <0-
16777215>
no area <area-id> default-cost
area <area-id> nssa
no area <area-id> nssa
area <area-id> nssa no-summary
no area <area-id> nssa no-summary
Chapter 61 OSPF Commands
Ethernet Switch CLI Reference Guide
233
DESCRIPTION
Sets the Switch to learn RIP routing
information which will use the specified
metric information.
Sets the Switch to redistribute RIP routing
information.
Route redistribution allows your Switch to
import and translate external routes
learned through other routing protocols (RIP
and Static) into the OSPF network
transparently.
Sets the Switch not to learn RIP routing
information.
Sets the Switch to learn static routing
information which will use the specified
metric information.
Sets the switch to redistribute static routing
information.
Route redistribution allows your Switch to
import and translate external routes
learned through other routing protocols (RIP
and Static) into the OSPF network
transparently.
Sets the Switch not to learn static routing
information.
Sets the interface to be passive. A passive
interface does not send or receive OSPF
traffic.
Sets the interface to not be passive.
Sets a summary address which is a network
IP address used to cover more than one
network routing entry in order to reduce the
routing table size.
Removes a summary address.
Displays all summary addresses on the
Switch.
Enables and enters the IPv6 OSPF
configuration mode.
Enables and sets the area ID.
Removes the specified area.
Sets the cost to the area.
Sets the area to use the default cost (15).
Enables and sets the area as a not-so-stubby
area.
Disables not-so-stubby network settings in
the area.
Sets the not-so-stubby area not to send any
LSA (Link State Advertisement).
Sets the not-so-stubby area to send LSAs
(Link State Advertisements).
M
P
C
13
C
13
C
13
C
13
C
13
C
13
C
13
C
13
C
13
C
13
E
3
C
13
C
13
C
13
C
13
C
13
C
13
C
13
C
13
C
13
Hide quick links:
Advertisement
Table of Contents
