Layer 2 Protocol Tunnel (L2Pt) Commands - ZyXEL Communications XS3800-28 Cli Reference Manual

Layer 2 Protocol Tunnel
43.1 Command Summary
The following section lists the commands for this feature.
Table 123 l2pt Command Summary
COMMAND
clear l2protocol-tunnel
interface port-channel <port-list>
l2protocol-tunnel
l2protocol-tunnel cdp
l2protocol-tunnel mode
<access|tunnel>
l2protocol-tunnel point-to-
point
l2protocol-tunnel point-to-
point lacp
l2protocol-tunnel point-to-
point pagp
(L2PT) Commands
DESCRIPTION
Removes all layer 2 protocol tunneling counters.
Enters config-interface mode for configuring the
specified port(s).
Enables layer 2 protocol tunneling for CDP (Cisco
Discovery Protocol), STP (Spanning Tree Protocol) and
VTP (VLAN Trunking Protocol) packets on the specified
port(s).
Enables layer 2 protocol tunneling for CDP packets on
the specified port(s).
Sets the L2PT mode for the specified port(s)
access: for ingress ports at the edge of the service
provider's network. The Switch encapsulates the
incoming layer 2 protocol packets and forward them
to the tunnel port(s).
Note: You can enable L2PT services for STP,
tunnel: for egress ports at the edge of the service
provider's network. The Switch decapsulates the
encapsulated layer 2 protocol packets received on a
tunnel port by changing the destination MAC address
to the original one, and then forward them to an
access port. If the service(s) is not enabled on an
access port, the protocol packets are dropped.
Enables point-to-point layer 2 protocol tunneling for
LACP (Link Aggregation Control Protocol), PAgP (Port
Aggregation Protocol) and UDLD (UniDirectional Link
Detection) packets on the specified port(s).
Enables point-to-point layer 2 protocol tunneling for
LACP packets on the specified port(s).
Enables point-to-point layer 2 protocol tunneling for
PAgP packets on the specified port(s).
Ethernet Switch CLI Reference Guide
175
C
H A P T E R
LACP, VTP, CDP, UDLD, and PAGP on the
access port(s) only.
43
M P
E 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13