Cluster Commands - ZyXEL Communications XS3800-28 Cli Reference Manual

Use these commands to configure cluster management.
16.1 Command Summary
The following section lists the commands for this feature.
Table 38 cluster Command Summary
COMMAND
show cluster
cluster <vlan-id>
no cluster
cluster name <cluster name>
show cluster candidates
cluster member <mac> password
<password>
show cluster member
show cluster member config
show cluster member mac <mac>
cluster rcommand <mac>
no cluster member <mac>

Cluster Commands

DESCRIPTION
Displays cluster management status.
Enables clustering in the specified VLAN group.
Disables cluster management on the Switch.
Sets a descriptive name for the cluster.
<cluster name>: You may use up to 32 printable
characters (spaces are allowed).
Displays the switches that are potential cluster members.
The switches must be directly connected.
Adds the specified device to the cluster. You have to
specify the password of the device too.
Displays the cluster member(s) and their running status.
Displays the current cluster member(s).
Displays the running status of the cluster member(s).
Logs into the CLI of the specified cluster member.
Removes the cluster member.
Ethernet Switch CLI Reference Guide
64
C
H A P T E R
16
M P
E 3
C 13
C 13
C 13
E 3
C 13
E 3
E 3
E 3
C 13
C 13