Auto Configuration Commands - ZyXEL Communications XS3800-28 Cli Reference Manual

Use these commands to configure auto configuration on the Switch.
9.1 Auto Configuration Overview
The Switch can download a pre-saved auto configuration file automatically when you reboot the
Switch using the DHCP or HTTPS mode. This will overwrite the running configuration stored in the Switch's
RAM instead of the startup configuration stored in the Switch's flash memory.
You can use the DHCP mode to load an auto configuration file from a TFTP server automatically when
you reboot the Switch. The Switch must have a dynamic IP address assigned by a DHCP server. Also,
make sure the Switch can communicate with the TFTP server.
Note: You need to set up configurations on a DHCP server and TFTP server first to use auto
configuration.
9.2 Command Summary
The following section lists the commands for this feature.
Table 24 auto-config Command Summary
COMMAND
auto-config
no auto-config
auto-config <dhcp | https>
Auto Configuration
DESCRIPTION
Enables auto configuration. When auto configuration is
enabled, the Switch can receive an auto configuration
file.
Disables auto configuration.
Selects the DHCP or HTTPS mode for auto configuration.
dhcp: Enables the DHCP mode for auto configuration.
When auto configuration DHCP is enabled, the Switch can
receive an auto configuration file from a TFTP server. The
location of the TFTP server is provided by a DHCP server.
https: Enables the HTTPS mode for auto configuration.
When auto configuration HTTPS is enabled, the Switch will
use the URL you specified using the auto-config url
command to access a web server and download the
auto configuration file using HTTPS.
Ethernet Switch CLI Reference Guide
40
C
H A P T E R
Commands
9
M P
C 14
C 14
C 14