Poe Commands - ZyXEL Communications XS3800-28 Cli Reference Manual

Use these commands to configure Power over Ethernet (PoE). These are applicable for PoE models only.
63.1 Command Summary
The following section lists the commands for this feature.
Table 160 pwr Command Summary
COMMAND
interface port-channel <port-list>
extend-range
no extend-range
pwr auto-pd-recovery
no pwr auto-pd-recovery
pwr continuous-poe
no pwr continuous-poe

PoE Commands

DESCRIPTION
Enters config-interface mode for the specified port(s).
Sets the port(s) to extend the PoE range up to 250
meters.
After you enable this feature, the port will transfer
data at a rate up to10 Mbps in full duplex mode. If a
PD is connected to the port, the Switch follows the
IEEE 802.3at PoE+ standard to supply power to the
connected PD during power-up.
Note: Maximum PoE power that can be
Note: If you enable extended range on a port
Note: The port speed and duplex mode you
Sets the port(s) to not extend the PoE range.
Turns on auto PD recovery on the Switch.
Turns off auto PD recovery on the Switch.
Enables this function to guarantee continuous power
supply to the connected PDs when you restart the
Switch (warm reboot) without physically turning the
power off. The Switch will NOT perform a power cycle
on the connected PDs.
If you do a cold reboot, the Switch also restarts the
connected PDs.
Disables continuous PoE on the Switch.
Ethernet Switch CLI Reference Guide
240
C
H A P T E R
supplied to a PD at 250 m is 15 W.
after the connected PD starts up
completely, you must disable PoE and
enable it again or disconnect and
reconnect the cable to the port for
extended mode to take effect.
previously configured will be applied
automatically when the extend range
feature is disabled.
63
M P
C 13
C 13
C 13
C 13
C 13
C 13
C 13