Internet Connection; The Default Configured Wan Interfaces Available; Bridge Mode (In The Following Example To Configure A Bridge Wan Interface, The Ethernet Wan Is Used.) - ZyXEL Communications P-2812HNU-51c Support Notes

Internet Connection

The Default Configured WAN Interfaces Available

In the default configuration file, there are already 3 WAN interfaces configured which
are Ethernet WAN (eth4100), ADSL WAN (atm0), and VDSL WAN (ptm0.100). On
Network>WAN>Internet Connection page, the current mode will be identified.
Please refer to the Web GUI page below:
NOTE: The following sections are step by step examples of how to configure
different Internet Connection types (PPPoE, IPoE, and Bridge) with different WAN
interfaces (Ethernet, VDSL, and ADSL).
Bridge Mode (In the following example to configure a bridge WAN
interface, the Ethernet WAN is used.)
Scenario:
The P2812HNU-51c is a CPE bridge.
a. Bridge Mode
1. Go to Network > WAN > Internet Connection.
2. Click Add
3. Select the Layer 2 interface for this service, e.g "eth4.100"
All contents copyright (c) 2009 ZyXEL Communications Corporation.
P-2812HNU-51C Support Notes