ZyXEL Communications XS3800-28 Cli Reference Manual page 358

Table 228 VRRP Command Summary (continued)
COMMAND
preempt
exit
no router vrrp network <ip-address>/<mask-
bits> vr-id <1~7>
interface route-domain <ip-address>/<mask-
bits> ip vrrp authentication-key <key>
interface route-domain <ip-address>/<mask-
bits> no ip vrrp authentication-key
show router vrrp
103.3 Command Examples
The following figure shows a VRRP network example with the switches (A and B) implementing one
virtual router VR1 to ensure the link between the host X and the uplink gateway G. Host X is configured
to use VR1 (192.168.1.254) as the default gateway. Switch A has a higher priority, so it is the master
router. Switch B, having a lower priority, is the backup router.
Figure 13 Example: VRRP
X
Default Gateway
10.10.1.254
Chapter 103 VRRP Commands
10.10.1.252
Priority = 200
PVID = 100
A
VRID = 1
VR1
10.10.1.254
B
10.10.1.253
Priority = 100
PVID = 100
Ethernet Switch CLI Reference Guide
358
DESCRIPTION
Enables preemption mode.
Exits from the VRRP command mode.
Deletes VRRP settings.
Sets the VRRP authentication key.
key: Up to 8 alphanumeric characters.
Resets the VRRP authentication key.
Displays VRRP settings.
172.16.1.1
PVID = 200
172.16.1.200
PVID = 200
172.16.1.10
M P
C 13
C 13
C 13
C 13
C 13
C 13