Siemens SIDOOR AT40 System Manual page 15

Parameter assignment and configuration
Risk of injury and material damage due to excessive forces of the door
Exceeding the maximum static closing force and opening force, if present, may lead to
injuries to persons or damage to the door drive and mechanical components of the door.
After commissioning, have the maximum static forces checked by the service personnel,
and adjusted to the limit value if it is excessive.
Observe the limit values of the applicable standards and adjust the set values accordingly.
Note
Application-specific measures for emergency operation
In the event of a controller failure, measures must be taken for emergency operation
according to the application.
Modifications to the door drive
Loss of liability for defects and material damage
Changes to the door drive lead to the loss of liability for defects and compensation rights,
and the correct function of the door drive is no longer guaranteed.
Note the following rules:
• Do not make any modifications to the door drive (motor, controller, power supply).
• Do not make a permanent connection as this does not ensure a proper and required
• Do not remove the protective Schuko-type socket under any circumstances (for example
• The power supply cable (SIDOOR Transformer or SIDOOR NT40) cannot be replaced.
AT40, ATD400V, ATD400K, ATD4xxW, ATD400S, ATE250S, ATD400T
System Manual, 06/2016, A2B00096162-AN
WARNING
CAUTION
necessary disconnection from the mains.
by cutting it off).
Scrap the power supply if the supply cable is damaged.
General safety instructions
15