Siemens SIDOOR AT40 System Manual page 112

Controllers
6.4 Operation and parameter assignment
Learn run (during operation)
Table 6- 14 Starting a learn run during operation
Procedure
1. Push the door into the CLOSED position.
2. Press and hold down the learn run button (S401 / S1
3. The learn run starts automatically, and the learn run button can be
released.
4. During the learn run, the door is opened about 10 cm, and closed once
or twice at creep speed. The friction of the door system is then deter-
mined by opening and closing the door once through a range of 25 cm
at creep speed. The door then opens and closes through its complete
range of movement at reduced speed. After the door has opened
approximately 15 cm, it passes through an additional short accelera-
tion ramp to determine the weight of the door.
5. The door parameters and the determined door width are saved when
the door is in the CLOSED position.
This means that the door width, door weight, energy limiting, speed
limiting and friction compensation
6. Learn run completed.
for SIDOOR ATE250S
1)
not for SIDOOR ATE250S
2)
SIDOOR ATD4xxW
3)
Service buttons OPEN and CLOSE
Door movements in the OPEN and CLOSE directions can also be made manually with the
service buttons S402 / S2* (OPEN) and S403 / S3* (CLOSE).
* SIDOOR ATE250S
The service buttons are located parallel to the OPEN and CLOSE signals, which are output
at X6. Each of these service buttons has to be pushed continuously to reach the limit
position of the door, because the door stops when the button is released.
If the OPEN and CLOSE buttons are pressed simultaneously or the OPEN and CLOSE
signals are present simultaneously, the door always moves in the OPEN direction.
Note
Operation with the SIDOOR Service Tool or the SIDOOR User Software
The doors can also be controlled with the SIDOOR Service Tool or the SIDOOR User
Software. In this case, the external input signals are disabled in some menus. You will find
more information in Section SIDOOR Service Tool (Page 292) and in the SIDOOR Software
Kit Operating Instructions (http://support.automation.siemens.com/WW/view/en/92711247).
112
).
1)
2)
are re-adapted and saved.
3)
AT40, ATD400V, ATD400K, ATD4xxW, ATD400S, ATE250S, ATD400T
H401 display H1 display
System Manual, 06/2016, A2B00096162-AN