Siemens SIDOOR AT40 System Manual page 119

Full parameter name
Continuous torque (power) OPEN
Continuous torque (power) CLOSE
Cutter press-on torque CLOSE
Static opening force
Static closing force
Static cutter force CLOSE
Static nudge force CLOSE / static NDG force
(reduced)
Additional profile parameters for SIDOOR ATD4xxW
Limit energy close
Limit energy OPEN
Limit energy NDG
Special parameters for SIDOOR ATD400K
Hold-open time standard
Hold-open time cord-operated switch
Opening width as a percentage
Special parameters for SIDOOR ATD4xxW
Slave ID
Int. Baud rate
PKW words
PZD words
Function input 1
Partial opening width
Additional profile parameter for SIDOOR ATD400T
Reversing distance CLOSE
Time parameters for SIDOOR ATD400T
Hold-open time after OPEN command
Hold-open time after motion detector
Hold-open time after obstruction
Time delay in wait mode CLOSE
Delay time in wait mode OPEN
Number of CLOSE obstructions before wait mode blockages before wait mod.CLS
Number of OPEN obstructions before wait mode
Time limit motion detector
Time delay motion
for SIDOOR ATD4xxW
1)
AT40, ATD400V, ATD400K, ATD4xxW, ATD400S, ATE250S, ATD400T
System Manual, 06/2016, A2B00096162-AN
1)
6.4 Operation and parameter assignment
Parameter name as shown in the software
idle torque open
idle torque close
peak torque close
limit force open
limit force close
limit force end close
lim.force close nudging / NDG force (redu)
limit energy close
limit energy open
limit energy NDG
open hold time normal
open hold time pull switch
open width in percent
Slave ID
Int. Baud rate
PKW words
PZD words
Function input - 1
Partial opening width
reversal dist. CLS
hold-open time a. open com.
hold-open time a. mot. det.
hold-open time a. blockage
delay time wait mode CLS
delay time wait mode OPEN
blockages before wait mod.OPEN
limited time mot.det.
time delay bef. movement
Controllers
1)
119