Cutting Width Correction Function - YASKAWA Motoman NX100 Manual

HW0482342
3.3

Cutting Width Correction Function

The cutting width correction function shifts the scale of the cutting width of the laser for the
cutting path when cutting the form according to the pattern. The following parameter is used
for the setting.
Parameter
S3C450
Set the cutting width of the laser to 1/2 of its value. When cutting, the path is corrected by the
parameter set values.
The following illustration is an example of the path correction when cutting the ellipse pattern.
The correction for the motion path is similar when using the other patterns.
The center of the circle does not change before and after the cutting width correction.
Contents
Cutting width correction (in
units of 0.001 mm)
When the cutting width correction value is (+)
When no cutting width correction
When the cutting width correction value is (-)
The set value at S3C450
3-5
3.3 Cutting Width Correction Function
Initial Value
0 mm
HW0482342