YASKAWA Motoman NX100 Manual page 44

6.1 Settings
1
2
3
4
5
6
7
8
9
10
11
12
13
COND NO. (1 to 200)
Form cut setting file condition No.
FIGURE
Select the desired pattern.
A circle, rectangle, ellipse, pentagon, or hexagon can be selected.
CUTTING SPEED
Set the cutting speed.
Dimensions
Set the dimensions of the pattern.
The items to be set are marked with " " while the items not to be set are marked with
" ".
Set a numerical value in the items marked with " ".
START POINT
Select the starting point.
The "CENTER", "PLACEMENT" or "AUTO" are choices for selecting a starting point.
When "CENTER" is selected, the cutting motion starts from the center of the cutting pattern.
When "PLACEMENT" is selected, the cutting motion starts from a point near the cutting pat-
tern that is defined by "CUT IN LENGTH" and "CUT IN ANGLE".
When "AUTO" is selected, the cutting motion starts from either the point used for "CENTER"
or the point used for "PLACEMENT", depending on the dimensions of the pattern.
When the "FIGURE" is a circle, an ellipse, a pentagon or a hexagon:
The starting point is the CENTER where (Radius×2)<=S1C G66×10
The starting point is the PLACEMENT where (Radius×2)>S1C G66×10
When the "FIGURE" is a rectangle:
The starting point is the CENTER where height<=S1C G66×10
The starting point is the PLACEMENT where height>S1C G66×10
JOB EDIT DISPLAY
FORM CUT SETTING
COND NO. : 1 / 200
FIGURE CIRCLE
CUTTING SPEED 10.0 mm/sec
RADIUS 150.000 mm
ROUNDNESS ERR 0.250 mm
WIDTH 0.000 mm
HEIGHT 0.000 mm
CORNER RADIUS 0.000 mm
START POINT CENTER
END POINT PATH
CUT IN LENGTH 5.0 mm
CUT IN ANGLE 45.0 deg.
AMOUNT OF OVERLAP 10.000 mm
FIRST STOP TIME 0.50 sec
SECOND STOP TIME 0.00 sec
ROTATION DIRECTION W
ROTATION ANGLE 0.0 deg.
Main Menu ShortCut
6-2
UTILITY
PAGE
Please set ( ) data only
-3
.
-3
-3
.
-3
.
HW0482342
HW0482342
.