Honeywell Galaxy Flex Installer Manual page 87

Galaxy Flex Installer Manual
Note: The communication module may take up to 40 seconds to alert the panel of a Line
Fail condition. This time is in addition to the programmed time of 0 to 1800
seconds.
This parameter affects all communication modules on the system.
Alert Inds [51.69]
Use this option to switch off the audio alert indication.
0=No Indication
1=Audio Only (default setting)
2=Visual Only (only when parameter 63 enabled)
3=Audio/Visual (only when parameter 63 enabled)
SWDC Set Dly [51.70]
Enable this parameter to delay the indication of open zones at the start of a set sequence
while the Switch DC output (53.08) is active. This includes keypad text and sounders.
If there are no outputs programmed as Switch DC, there is no delay at the start of the set.
MF BL Enable [51.71]
Enable this option to send an SIA event if the battery is low and there is a mains power
failure. When the event is sent, the Power Delay time set in parameter 51.20 stops
immediately.
Max Alm Cause [51.72]
Use this option to define the range of valid cause codes agreed with the Alarm Receiving
Centre. When this function is enabled, a cause code must be entered by the user to perform a
system reset. To disable, set the alarm cause code to 000.
Guard Unset [51.73]
Enable this option to allow a type 1 user code to unset the system if an alarm has occurred.
This gives the type 1 user 60 minutes to check for the cause of the alarm and set the system.
Once the system is set the type 1 user can no longer unset it.
Backup Link [51.74]
Use this option to switch to another communications method if the current one fails to
report.
0=Disabled
1=GPRS-PSTN
To switch to Telecoms communication if the Ethernet/GPRS fails to
report.
2=PSTN-GSM To switch to GSM communication if the Telecoms fails to report.
3=GPRS-GSM
To switch to GSM communication if the GPRS fails to report.
Parameters [51]
87