Honeywell Galaxy Flex Installer Manual page 156

Keypad [58]
Show Status [58.6]
Enable this option to allow the set status of the groups to be displayed.
To display group set status, press
F = Fault
R = Ready
S = Set
P = Part Set
– = Group not assigned to keypad
Note: This option works when the system is set (keypad blank) or unset (normal banner).
It does not operate in engineer mode.
To show the status of the groups individually, press
To move between each groups, press
To return to the banner display, press
Keypad Groups [58.7]
You can assign each keypad to selected groups. The keypad then responds only to user
codes that have a group common to it and only displays alarm information on the groups
assigned.
Entering a user code, assigned to all groups on a keypad, which is only assigned to a single
group, allows access to all of the user's groups. The user is not restricted by the groups that
are assigned to the keypad as long as there is one group common to both. This means that a
keypad assigned to group 1 only, for example, can be used to set groups 1, 2, 3 and 4 by
using a code with all of these groups allocated.
Keypad Group Restriction
To restrict access only to groups that are common to both the user and the keypad, press the
when assigning groups to the keypad. This means that when a user with access to groups
1, 2 and 3 sets the system on a keypad assigned to groups 2, 3 and 4, only the common
groups (groups 2 and 3) are set.
Assigning Keypad Groups
On selecting the Keypad Groups option, the groups currently allocated to the keypad are
displayed (the default is all groups assigned). Pressing the group number toggles the group
assigned to the keypad.
Note: Also see option 53, to control the buzzer operation on each keypad. This is
independent of the keypad group parameter.
156
and together.
#
STATUS 12345678
Groups RRSRSPFP
group block
and
and or and
A B
and again.
#
Galaxy Flex Installer Manual
again.
#
together.