Honeywell Galaxy Flex Installer Manual page 79

Galaxy Flex Installer Manual
PA Reset [51.22]
Use this option to select the user type that can reset the system following a PA activation. A
remote code can also change this option. The default type is 3 and the range is
3 to 5 for the user.
6 for the manager.
7 for the engineer.
You can assign a different value to each group.
The panel only requests Engineer Level Reset if alarms have been signalled via the
Communication Module and appropriate type reset is set to 7. If no signal is transmitted, the
reset is automatically reduced to type 6. This feature is only active when the DTMF
signalling format is selected.
Exit Alarm [51.24]
Use this parameter to enable a full alarm condition to activate if any zone other than Final,
Exit, Entry or Push-Set (or Secure Final or Part Final when acting as a Final) is opened
during the exit time causes. The default is 0 (disabled).
Note: This option must be used only when specified.
You can assign a different value to each group.
If the Exit Alarm parameter is enabled, any zone that is open when the Autoset begins (at
the end of the pre-warning period) causes an immediate full alarm condition to be activated.
If the Exit Alarm parameter is disabled, any zone open when the Autoset begins (at the end
of the pre-warning period) results in an urgent bleeping from the entry/exit horns. If the
open zones are not closed by the end the time assigned in parameter 35=Fail To Set, a full
alarm is activated along with any outputs programmed as Fail-Set.
CCT Debounce [51.27]
Use this option to set the response time of the zones (how long they must remain open
before registering as changing state).
The default is 300 milliseconds and the range is 20 to 1000 milliseconds (0.02 to 1 second).
All entries are rounded up to the nearest 20 ms.
Note: The value programmed in this option is the value allocated to the SYSTEM
selection when programming zone response time in option 52.
Online Print [51.28]
Use this parameter to select the print mode required when connecting a printer to the panel.
There are two options:
0=DISABLED (default) The system only prints specific details at the user's request. The
printer can be connected and disconnected at any time.
Parameters [51]
79