Configuring Leds To Blink On The Display Panel - Avaya 3500 Series Getting Started

Configuring the switch using ACLI
Example
The following figure provides a sample of the show sys-info command.
Switch#show sys-info
Operation Mode:
MAC Address:
Reset Count:
Last Reset Type:
Autotopology:
Pluggable Port 47:
Pluggable Port 48:
Pluggable Port 49:
Base Unit Selection:
sysDescr:
Serial #:
Operational Software:
Installed software:
Operational license:
Installed license:
sysObjectID:
sysUpTime:
sysNtpTime:
sysServices:
sysContact:
sysName:
sysLocation:
Stack sysAssetId:
Unit sysAssetId:

Configuring LEDs to blink on the display panel

Use this procedure to set the LEDs on the display panel to blink to identify a particular unit.
Procedure
1. Enter Privileged EXEC mode:
enable
2. At the command prompt, enter the following command:
blink-leds [off | time <1–10> | unit <1–8>]
Variable definitions
The following table describes the parameters for the blink-leds command.
Variable
off
time <1–10>
Getting Started with Avaya ERS 3500 Series
64
Switch
B4-A9-5A-FD-6C-00
58
Software Download
Enabled
None
None
None
Non-base unit using rear-panel switch
Ethernet Routing Switch 3549GTS
HW:R0A FW:1.0.0.11
Mfg Date:20130619
SDNI49GA0012
FW:1.0.0.11 SW:v5.2.0.037
FW:1.0.0.11 SW:v5.2.0.037
Base software
Base software
1.3.6.1.4.1.45.3.80.7
1 day, 04:31:04
NTP not synchronized.
6
3549GTS
Comments on this document? infodev@avaya.com
SW:v5.2.0.037
HW Dev:none
Value
Sets the LEDs to stop blinking
Indicates the duration, in minutes, for the LEDs to
blink to identify the unit.
RANGE: 1 to 10 minutes
Table continues...
July 2015