Managing Ethernet ports using ACLI
Naming ports
You can name ports, change the name, clear the name or reset the port name to an empty string.
Procedure
1. Enter Interface Configuration mode:
enable
configure terminal
interface Ethernet <port> or interface vlan <1–4094>
2. At the command prompt, enter the following command:
[no] [default] name [port <portlist>] <LINE>
Variable definitions
The following table describes the parameters for the name [port <portlist>] command.
Variable
port<portlist>
<LINE>
no
default
Setting port speed
Set the speed of a port. Ports can be set to a speed of 10 Mb/s, 100 Mb/s, 1000 Mb/s (or 1 GB/s), or
auto-negotiated.
Procedure
1. Enter Interface Configuration mode:
enable
Getting Started with Avaya ERS 3500 Series
98
Value
Specifies the port numbers to be named.
Specifies the name of the port using up to 26
alphanumeric characters.
Clears the port names and resets the field to an
empty string.
Clears the port names and resets the field to the
default value (an empty string).
Comments on this document? infodev@avaya.com
Important:
If you omit this parameter, the system uses the
port number you specified in the interface
command.
July 2015