Configuring The Terminal - Avaya 3500 Series Getting Started

4. Set the terminal protocol on the terminal or terminal emulation program to VT100 or VT100/
ANSI.
5. Connect to the switch using the terminal or terminal emulation application. The Avaya switch
banner appears when you connect to the switch through the console port.
6. Enter Ctrl+Y and type the following CLI commands:
enable
install
The setup utility prompts you to enter the information requested as shown below.
#########################################################################
Welcome to the ERS3500 setup utility.
You will be requested to provide the switch basic connectivity settings.
After entering the requested info, the configuration will be applied and
stored into the switch NVRAM.
Once the basic connectivity settings are applied, additional configuration
can be done using the available management interfaces.
Use Ctrl+C to abort the configuration at any time.
#########################################################################
Please provide the Quick Start VLAN <1-4094> [1]:
Please provide the in-band IP Address[192.168.1.1]:
Please provide the in-band sub-net mask[255.255.255.0]:
Please provide the Default Gateway[0.0.0.0]:
Please provide the Read-Only Community String[**********]:
Please provide the Read-Write Community String[**********]:
Please provide the in-band IPV6 Address/Prefix_length[::/0]:
Please provide the in-band IPV6 Default Gateway[::]:
Do you want to enable the DHCP server? y/n [n]:
#########################################################################
Basic stack parameters have now been configured and saved.
#########################################################################

Configuring the terminal

You can configure the switch terminal settings to suit your preferences for the terminal speed and
display.
About this task
Use the following procedure to configure terminal settings including the terminal connection speed,
and terminal display width and length, in number of characters.
Procedure
1. Log on to ACLI to enter User EXEC mode.
2. To display the current serial port information, enter the following command:
July 2015
Comments on this document? infodev@avaya.com
Getting Started with Avaya ERS 3500 Series
Configuring the terminal
39