Displaying The Current Configuration - Avaya 3500 Series Getting Started

Configuring the switch using ACLI
default switch configuration. If you want to view the entire configuration, you must use the verbose
qualifier to view the configuration for a specific feature.
A configuration file obtained from a stand-alone switch can only be used to configure other stand-
alone switches that have the same firmware revision and model type as the donor stand-alone
switch.
The following parameters are not saved to the configuration file:
• Configuration Image Filename
• Terminal settings (speed, width, length)
For more information, see Fundamentals of Avaya Ethernet Routing Switch 3500 Series,
NN47203-102, for procedures on
• Viewing current configuration using ACLI
• Saving current configuration using ACLI
• Saving current configuration to flash memory using ACLI
• Restoring system configuration from TFTP using ACLI
• Downloading a configuration file automatically using ACLI
• Storing current ASCII configuration on a TFTP server using EDM
• Downloading an ASCII configuration from a TFTP server using EDM
• Downloading a configuration file automatically using EDM
• Storing a binary configuration file on a TFTP server using EDM
• Downloading a binary configuration file on a TFTP server using EDM
• Saving current configuration to flash memory manually using EDM

Displaying the current configuration

Use this procedure to display the current configuration of the switch or stack.
Procedure
1. Enter Privileged EXEC mode:
enable
2. At the command prompt, enter the following command:
show running—config [verbose] [module <value>]
Important:
If the switch CPU is busy performing other tasks, the output of the show running-
config command can appear to intermittently stop and start. This is normal operation
to ensure that other switch management tasks received appropriate priority.
Getting Started with Avaya ERS 3500 Series
52
Comments on this document? infodev@avaya.com
July 2015