Specifying Duplex Operation For A Port - Avaya 3500 Series Getting Started

Ethernet routing switch
Hide thumbs Also See for 3500 Series:
Table of Contents

Advertisement

configure terminal
interface Ethernet <port> or interface vlan <1–4094>
2. At the command prompt, enter the following command:
[default] speed [port <portlist>] {10|100|1000|auto}
Variable definitions
The following table describes the parameters for the speed [port <portlist>] command.
Variable
default
port <portlist>
10|100|1000|10000|auto

Specifying duplex operation for a port

Specify duplex operation as full-duplex mode , half-duplex mode, or auto-negotiated. You can also
reset duplex operation for a port to the factory default duplex value.
Procedure
1. Enter Interface Configuration mode:
enable
July 2015
Value
Sets the speed of the port to the factory default
speed.
Specifies the port numbers to configure the speed.
Enter the port numbers to be configured.
Sets speed to:
• 10 — 10 Mb/s
• 100 — 100 Mb/s
• 1000 — 1000 Mb/s or 1 Gb/s
• 10000 — 10000 Mb/s or 10 Gb/s
• auto — autonegotiation
Comments on this document? infodev@avaya.com
Specifying duplex operation for a port
Important:
If you omit this parameter, the system uses the
port number you specified in the interface
command.
Important:
When you set the port speed for
autonegotiation, ensure that the other side of
the link is also set for autonegotiation.
Getting Started with Avaya ERS 3500 Series
99

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents