Changing Switch Software Using Edm - Avaya 3500 Series Getting Started

AUR tab field descriptions
The following table describes the fields on the AUR tab.
Name
AutoUnitReplacementEnabled
AutUnitReplacementSaveEnabled
AutUnitReplacementForceSave
AutUnitReplacementRestore

Changing switch software using EDM

Use this procedure to change the software version running on the switch.
Procedure
1. In the navigation tree, click Edit.
2. In the Edit tree, click File System.
3. On the work area, click the Config/Image/Diag file tab.
4. In the TftpServerInetAddressType section, click a radio button.
5. In the TftpServerInetAddress dialog box, type the TFTP server IP address.
6. In the BinaryConfigFileName dialog box, type the name of the binary configuration file.
7. In the ImageFileName dialog box, type the name of the current image file.
8. In the FwFileName(Diagnostics) dialog box, type the name of the current diagnostic file.
9. In the Action section, click a radio button.
10. On the toolbar, click Apply.
Config/Image/Diag file tab field descriptions
The following table describes the fields on the Config/Image/Diag file tab.
Name
TftpServerInetAddressType
July 2015
Description
Specifies whether AUR is enabled.
Specifies whether AUR Save is enabled.
Specifies whether an immediate save of the new
base unit (NBU) configuration to the base unit (BU)
is forced.
Specifies whether the configuration of a unit from the
saved configuration on the base unit is restored.
Description
Specifies the type of TFTP address:
• IPv4
• IPv6
Comments on this document? infodev@avaya.com
Configuring the switch using EDM
Getting Started with Avaya ERS 3500 Series
Table continues...
129