Viewing Flash History Using Acli - Avaya 3500 Series Getting Started

Configuring the switch using ACLI
Viewing the port-based AES configuration using ACLI
Use the following procedure to review AES configuration for all ports on the switch, an individual
port, or range of ports.
Procedure
1. Log on to ACLI to enter User EXEC mode.
2. View AES savings.
show energy-saver interface <portlist>
Example
The following example displays sample output for the show energy-saver interface
command using the <portlist> variable.
switch> show energy-saver interface 1-6
Port AES State
---- ---------
1 Enabled
2 Enabled
3 Disabled
4 Enabled
5 Enabled
6 Disabled

Viewing FLASH History using ACLI

Use this procedure to view information about the number of writes or modifications on the FLASH
device. You can display FLASH information on both single and stacked switches. You can also
display FLASH information for a specific unit.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. Enter the following command:
show flash history [unit <1 – 8 >]
Note:
The Flash History does not record programming done from the diagnostics or
bootloader.
Example
The following is an example for a single unit.
----------------------------------------------------------------------------
FLASH Write History Unit:
----------------------------------------------------------------------------
Getting Started with Avaya ERS 3500 Series
90
PoE Savings
-----------
N/A
N/A
N/A
N/A
N/A
N/A
Comments on this document? infodev@avaya.com
PoE Priority
------------
N/A
N/A
N/A
N/A
N/A
N/A
July 2015