Aaur Configuration - Avaya 3500 Series Getting Started

show stack-info
Example
The following figure provides a sample of the show stack-info command.
Switch#show stack-info
Unit# Switch Model
----- ---------------- --------- --------- --------- --------- ----------
1 3549GTS
2 3524GT-PWR+
3 3526T-PWR+

AAUR configuration

Use ACLI procedures in the following sections to manage and configure Agent Auto Unit
Replacement (AAUR). You can currently manage this functionality only through ACLI.
Enabling or disabling AAUR
Use this procedure to enable or disable AAUR.
Note:
AAUR is recommended and enabled by default.
Before you begin
AAUR requires a stack configuration
About this task
You can use the AAUR feature to ensure that all units in a stack run the same software image.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. To enable AUR, enter the following command:
stack auto-unit-replacement-image enable
3. To disable AUR, enter the following command:
no stack auto-unit-replacement-image enable
4. To default AUR, enter the following command:
default stack auto-unit-replacement-image enable
The default is enabled.
July 2015
Pluggable Pluggable Pluggable Pluggable SW Version
Port Port
(47) SX (48) SX (49) SR
(21) SX (22) SX (23) SX
(25) SX (26) SX
Comments on this document? infodev@avaya.com
Configuring the switch using ACLI
Port Port
v5.2.0.037
(24) SX v5.2.0.037
v5.2.0.037
Getting Started with Avaya ERS 3500 Series
83