Chapter 13: Configuring The Switch Using Edm; Configuring The Switch Using Edm; Configuring Quick Start Using Edm - Avaya 3500 Series Getting Started

Chapter 13: Configuring the switch using

Configuring the switch using EDM

Configuring Quick Start using EDM

Perform this procedure to configure Quick Start to enter the setup mode through a single screen.
Procedure
1. From the navigation tree, click Administration.
2. In the Administration Tree, click Quick Start.
3. In the In-Band Switch IP address, type a switch address.
4. In the In-Band Subnet Mask dialog box, type a subnet mask.
5. In the Default Gateway dialog box, type an IP address.
6. In the Read-Only Community String box, type a character string.
7. In the Re-enter to verify dialog box immediately following the Read-Only Community String
box, retype the character string from Step 6.
8. In the Read-Write Community String dialog box, type a character string.
9. In the Re-enter to verify dialog box immediately following the Read-Write Community String
box, retype the character string from Step 8.
10. In the Quick Start VLAN dialog box, type a VLAN ID.
11. To enable the DHCP Server, select the ServerEnablecheck box and enter the DHCP server
information.
12. Click Apply.
July 2015
EDM
Comments on this document? infodev@avaya.com
Getting Started with Avaya ERS 3500 Series
117