Simple Network Time Protocol - Avaya 3500 Series Getting Started

(((((VLAN ID port member configuration*****
Unit/Port VLAN VLAN Name
--------- ---- ---------------- ---- ---------------- ---- ----------------
1/1 1 VLAN #1
--------- ---- ---------------- ---- ---------------- ---- ----------------
*****Spanning-tree port configurations*****
Unit Port Trunk
---- ---- ----- ---------------
1 1 Normal Learning
Variable definitions
The following table describes the parameters for the show interfaces config command.
Variable
<portlist.>

Simple Network Time Protocol

The Simple Network Time Protocol (SNTP) feature synchronizes the Universal Coordinated Time
(UTC) to an accuracy within 1 second. This feature adheres to the IEEE RFC 2030 (MIB is the
s5agent). With this feature, the system can obtain the time from any RFC 2030-compliant NTP/
SNTP server.
The system retries connecting with the NTP server a maximum of 3 times, with 5 minutes between
each retry. If the connection fails after the 3 attempts, the system waits for the next synchronization
time (the default is 24 hours) and begins the process again.
Important:
If you have trouble using this feature, try various NTP servers. Some NTP servers may be
overloaded or currently inoperable.
Displaying SNTP information
Display the SNTP information, as well as the configured NTP servers.
Procedure
1. Enter Privileged EXEC mode:
enable
2. At the command prompt, enter the following command:
show sntp
Example
The following figure provides a sample output of the show sntp command.
switch#show sntp
SNTP Status:
Primary server address:
Secondary server address:
July 2015
VLAN VLAN Name
Participation Priority
--------
128
Disabled
0.0.0.0
0.0.0.0
Comments on this document? infodev@avaya.com
Configuring the switch using ACLI
VLAN VLAN Name
Path Cost State
--------- ----------
10 Forwarding
Value
Enter the ports you want to display.
Getting Started with Avaya ERS 3500 Series
69