Combination Switch - Mercedes-Benz Citan 2015 Operating Instructions Manual

Exterior lighting
78
X
Turn the key to position 2 in the ignition lock
or start the engine.
X
Turn the light switch to the L position.
X
Turn headlamp range control : downwards
to position the dipped beams lower and
upwards to position them higher.
X
Turn headlamp range control : to position 0
or 1 for an unladen vehicle and to positions 1
to 4 for a partially or fully laden vehicle.
The road ahead should be lit up for 40 mto
100 m and the dipped-beam headlamps
should not dazzle oncoming traffic.

Combination switch

Turn signal
X
To indicate: press the combination switch
beyond the pressure point in the direction of
arrow : or ;.
X
Brief turn signals: briefly press the combi-
nation switch in the direction of arrow :
or ;.
The turn signal flashes three times.
Main-beam headlamps and headlamp
flasher
X
To switch on the main-beam headlamps:
start the engine.
X
Turn the light switch to L or Ã.
X
Press the combination switch beyond the
pressure point in the direction of arrow :.
In the à position, the main-beam head-
lamps are only switched on when it is dark and
the engine is running.
The K indicator lamp in the instrument
cluster lights up when the main-beam head-
lamps are switched on.
X
To switch off the main-beam headlamps:
move the combination switch back to its nor-
mal position.
The K indicator lamp in the instrument
cluster goes out.
X
To switch on the headlamp flasher: turn
the key to position 1 or 2 in the ignition lock or
start the engine.
X
Pull the combination switch in the direction of
arrow ;.
Follow-me-home function
This function can be used to briefly switch on the
dipped-beam headlamps, e.g. when opening a
garage door. If the function is activated once,
the dipped-beam headlamps remain switched
on for 30 seconds after leaving the vehicle. You
can activate the function up to four times to give
a total operating time of 2 minutes.
X
To activate: pull the combination switch in
the direction of the arrow.
The dipped-beam headlamps switch on for
approx. 30 seconds.