Mercedes-Benz Citan 2015 Operating Instructions Manual page 198

Wheel and tyre combinations
196
emissions or fuel consumption, may other-
wise be adversely affected. In addition, when
driving with a load, tyre dimension variations
could cause the tyres to come into contact
with the bodywork and axle components. This
could result in damage to the tyres or the
vehicle.
Mercedes-Benz accepts no liability for dam-
age resulting from the use of tyres, wheels or
accessories other than those tested and
approved.
Further information on wheels, tyres and
approved combinations can be obtained from
any qualified specialist workshop.
! Retreaded tyres are neither tested nor rec-
ommended by Mercedes-Benz, since previ-
ous damage cannot always be detected on
retreaded tyres. As a result, Mercedes-Benz
cannot guarantee vehicle safety if retreaded
tyres are fitted. Do not fit used tyres if you
have no information about their previous
usage.
Large wheels: the lower the section width
!
for a certain wheel size, the lower the ride
comfort is on poor road surfaces. Roll comfort
and suspension comfort are reduced and the
risk of damage to the wheels and tyres as a
result of driving over obstacles increases.
Overview of abbreviations used in the following
tyre tables:
BA: both axles
R
You will find a table with recommended tyre
pressures for various operating conditions on
the inside edge of the driver's door. For further
information on tyre pressure, see (
Check tyre pressures regularly and only when
the tyres are cold.
Notes on the vehicle equipment – always fit the
vehicle:
with tyres of the same size across an axle
R
(left/right)
with the same type of tyres on all wheels at a
R
given time (summer tyres, winter tyres)
In the following table, the wheel/tyre combina-
tions are allocated to the vehicle models
through variants, e.g. V1, V2 etc.:
V1 Panel van (short)
V2 Panel van (long)/crewbus and normal
payload
V3
V4
Y
page 190).
Panel van (long)/crewbus and high pay-
load
Panel van (extra-long)/Mixto