Mercedes-Benz Citan 2015 Operating Instructions Manual page 45

5, 6
Rear seats
Weight category
Carry cot/pushchair attachment at right
angles to the direction of travel
0
0+
I
II
III
Suitability of the seats for attaching an ISOFIX child restraint system
If you are using a baby car seat of weight category 0 or 0+, or a category I rearward-facing child
restraint system on a rear seat, the driver's or front-passenger seat must be adjusted in such a way
that it does not come into contact with the child restraint system.
If you are using a category I, forward-facing child restraint system, you must remove the head
restraint of the respective seat (
must, as far as possible, rest against the backrest of the seat.
In addition, always observe the notes found under "Child restraint system" (
the child restraint system manufacturer's installation instructions.
When you remove the child restraint system, you must replace the head restraints again immedi-
Y
ately ( page 69). All vehicle occupants must adjust their head restraints correctly before begin-
ning the journey.
Legend for the table:
X ISOFIX position that is not suitable for ISOFIX child restraint systems in this weight category
and/or size category.
IUF Suitable for forward-facing ISOFIX child seat securing systems that belong to the "Universal"
category which are approved for use in this weight category.
IL Suitable for ISOFIX child restraint systems as recommended; see the following table of "Rec-
ommended child restraint systems" (
5 If you are using a baby car seat in the 0 or 0+ category on a rear seat, you must adjust the driver or front-
passenger seat so that the seat does not touch the baby car seat.
Child restraint systems are not permitted on a rear bench seat with a partition grille.
6
7 Fit the pushchair attachment across at least two seats. The child's head must be facing towards the centre
of the vehicle.
8 Move the front seat as far forward as possible when fitting the child seat. Then slide the front seat backwards
as specified in the child seat operating instructions. The front seat must not touch the child seat.
9 The child seat backrest must lie flush against the vehicle seat backrest. Adjust the head restraint height or
remove the head restraint completely. Move the seat in front of the child seat in the fore-and-aft direction to
the centre position. Do not tilt the seat backrest in front of the child seat more than 25°.
10 Move the rear seats in the third row to the rearmost position of the fore-and-aft adjustment.
The child seat backrest must lie flush against the vehicle seat backrest. Adjust the head restraint height or
11
remove the head restraint completely.
Left, right
7
U
up to 10 kg
8 8
U , L
up to 13 kg
8 8
U , L
9 kg to
8, 9
U , L
18 kg
15 kg to
9 9
U , L
25 kg
22 kg to
9 9
U , L
36 kg
Y
page 71), if possible. The backrest of the child restraint system
Y
page 45).
Children in the vehicle
Centre
X
8 8
U , L
8 8
U , L
8, 9 8, 9 8, 9
U , L
9 9
U , L
9 9
U , L
Y
Rear seats in
the third row
X
X
X
10, 11 10, 11
UF , L
10, 11 10, 11
UF , L
10, 11 10, 11
UF , L
page 37), as well as
Z
43